![pes 4 lamps electronic fluorescent ballast pes 4 lamps electronic fluorescent ballast](https://i.ebayimg.com/images/g/tXsAAOSwOIxczbKo/s-l640.jpg)
That may be a low cost experimental route. Then check out our great price on the Electronic Sign Ballast for 6,5,and 4 T12 HO lamps up to 8 ft long, it usually ships in 3-5 business days Length (L): 14.45' Width (W): 3.23' Height (H): 2.20' Mounting (M): 13.
#PES 4 LAMPS ELECTRONIC FLUORESCENT BALLAST FREE#
FREE Delivery on your first order of items shipped by Amazon. So where does that leave you? I have not tried it with an electronic ballast, but you may get away with just leaving the heater not connected, or you may not! With the high voltage and spikes around who knows what might happen?Īs a closing note, I did see during my browsing, that someone had extracted the electronics out of a compact fluorescent (failed tube) lamp and wired in their own tube. (1996) Electronic ballast with a high power factor for fluorescent lamps, 0-7803-3500-7/96. PES 4 Lamps Electronic Fluorescent Ballast, 120V, PES120ET8-12SMT-4. For example, 3200 lumens x 0.77 BF 2464 total system lumens. Multiply the rated lumens of your fluorescent lamp by the ballast factor to estimate your total system lumens. Without a heater you can be lucky with small tubes that just switching them on generates the ionising voltage spike and it fires up, or you need to switch off and on to strike the lamp. By selecting the ideal ballast factor, you can maximize your energy savings while tailoring the light output of your fluorescent fixture.
![pes 4 lamps electronic fluorescent ballast pes 4 lamps electronic fluorescent ballast](https://i.ebayimg.com/images/g/9n4AAOSw~y9ZAj9b/s-l640.jpg)
BUT there was a difference in the proper balast designs in that the two pin tubes needs a higher striking voltage (as the cathodes emit less at non-heated temperature) AND it was the heater current through the started that when it switched out caused the inductive kick to start the tube (which repeats if tube doesn't strike).
![pes 4 lamps electronic fluorescent ballast pes 4 lamps electronic fluorescent ballast](https://www.sanforce-tech.com/wp-content/uploads/2020/06/fluorescent-light-conversion-kits.jpg)
The old inductor, capacitor ballasts often could drive both types of tubes, simply by leaving one side of the heater wiring disconnected. Primarily if the a tube is to be switched on and off frequently a heater is used as this reduces cathode stripping and makes the tube last longer.įor a tube that's left running the cathode wear is not so significant so they save cost by not putting in a heater.
#PES 4 LAMPS ELECTRONIC FLUORESCENT BALLAST FULL#
Hi, as Audioguru said the difference is the heater which heats the cathodes. Yes when the fluorescent was made into a bulb they were very poor, but 2D was and still is a reasonable light, I prefer LED as fast switch on, and seem to give full output to the end, plus you can better select output, a 1.5 meter tube in fluorescent is 58 watt, around 5200 lumen although that is with magnetic ballast with electronic output is.